HandyPress® Ruler

This is an add-on accessory for the Sailrite® HandyPress®. This ruler allows you to accurately position your workpiece while cutting, installing hardware and stamping. There’s no need to measure and mark your project beforehand when you can do it all in one step with the HandyPress Ruler.

The HandyPress® Ruler attaches to the HandyPress® Sliding Flat Workbench (included with the tool) and is compatible with the HandyPress® Sliding Backstop for Use With Lower Dies (#126448, sold separately). It features inch marks on one side and centimeters on the other. With measurements mirrored on the top and bottom of the ruler, you can install it to the left or right of your HandyPress and the numbers will always display right side up.

Purchase the HandyPress® Backstop Extender (#126803, sold separately) for use with the standard Sliding Flat Workbench if a spacer is required when stamping. This is generally required for smaller stamping dies where close placement to the material edge is desired.

Add the HandyPress Ruler to your workbench for consistency and quality in your work.

Features:

• Double-sided ruler featuring imperial and metric measurements.
• Easy-to-read measurements with a 0 point for easy centering.
• Attaches to HandyPress workbench to ensure accuracy at any depth.

Please Note: HandyPress tool, adapters and dies are sold separately.