Use the Sailrite® HandyPress® to cut holes in fabric for installation of Twist-Lock eyelets with this hole cutter. This punch cuts an oval center hole and four small slits for the eyelet prongs in one quick and easy step. Use the HandyPress® Sliding Flat Workbench with the HandyPress® Cutting Board beneath the fabric assembly.

To Use: Install the punch into the main vertical shaft's inner diameter and secure with the thumbscrew. Set the workbench with cutting board so the back fence edge sets your desired fastener distance from the fabric edge. Set the tool for appropriate compression as directed in the HandyPress guidebook. Holding your assembly in place with one hand, pull the handle down to cut your material for hardware installation.

Tip: Add the optional HandyPress® Ruler (#126459) to aid in the consistency and efficiency of fastener hole spacing.

Please Note: Twist-Lock hardware sold separately.
 
Note: This hole cutter was designed for the HandyPress. To see if it is compatible with your hand press, check the Dimensions tab and verify that it will attach to your press.